is simply the fastest and easiest way to get full enjoyment from your
waterfront property. In cold climates, there’s no need to endure
frigid water -- just roll it in and you're ready for action. Roll-A-Dock
is ideally suited to gradual slopes and works equally well on soft or
rocky bottoms. A basic dock can be easily placed with a vehicle or installed
in a matter of minutes by as few as two people.
Adjustment Over a Wide Range of Depths
A built-in winch with removable hand crank allows quick height adjustment
for different depths or changing water levels. Adjustments are easily
made without ever stepping into the water. Standard Model adjusts from
2-1/2' to 5-1/2'. Deep Water Kit adjusts from 2-1/2' to 8'.
and 6' Widths, Aluminum or Galvanized Steel
While some portable docks are as narrow as 36", Roll-A-Dock gives
you the choice of 4' or 6' wide models - plenty of room for people to
meet and pass. Select all-aluminum construction for low weight and easy
handling or galvanized steel for maximum strength.
For details on decking materials, click here.
on 4' wide docks only.
Your Own Dock Layout
Roll-A-Dock is easily lengthened with add-on sections or expanded to form
“T”s, “L”s or side platforms. A wide variety of
accessories are also available. Add-on sections can be attached to one
or both sides. Available sizes: 2', 4', 6' widths, and 4', 8', 16' lengths.
Custom sizes also available. Shown below are just a few possible layouts.
Better to Better Meet Your Needs
With the strength of its design, Roll-A-Dock can be extended to virtually
any length you need. The basic starter unit is a 16' long wheel-end assembly.
4', 8' and 16' add-on sections can be connected to make a single free-span
dock up to 48' long. For greater lengths, simply install a dock hinge
and continue adding sections, wheel kits and supports. Ramps, triangular
sections and side sections are also available to complete your installation.
Roll-A-Dock will provide a lifetime of service. All-aluminum frames, galvanized
steel frames and all other components have been designed for low maintenance
and superior resistance to corrosion.
Roll-A-Dock's unique "V" type bracing reduces the clear
span on a 32' dock to only 21'. This design gives the wheel assembly
superior strength both front and rear and assures maximum stability
on soft or rocky bottoms.
With Roll-A-Dock's exclusive connecting system, there is no loss of
strength, even at the joints. The integrity of this design makes it
possible to have a steel frame dock up to 32' in length that requires
no extra supports.
The Roll-A-Dock tapered frame incorporates design principles proven
in bridge and rafter construction. This design provides maximum strength
with a minimum of weight. The open sides of the frame also improve
stability by reducing wave resistance.
The height adjusting winch and cable is located inside the dock frame
for greater safety. There are no exposed parts to snag --; nothing
to damage your boat when you pull along side.
The height adjusting winch is operated with a removable hand crank
that is inserted in an opening in the deck surface. Height adjustments
can be made while standing on the deck.
Light Dock Hinge
Recommended for use on longer, multi-section docks equipped with two
or more wheel bases.